IX. Graduate Programs
Engineering
PhD Program
The PhD program prepares candidates for a career in engineering teaching, research, or consulting. The program is designed to provide both broad knowledge of engineering science and training in advanced research. Doctoral research carries the expectation of making an original contribution to the body of existing knowledge or technology. It is also expected that the responsibility of problem definition and solution is that of the student, and that the student's advisor acts truly in an advisory capacity. Therefore, graduates are expected to have acquired autonomy in defining and analysing problems, conducting research, and preparing scholarly publications. These objectives are achieved through a combination of course work, independent research, a qualifying examination, and the production and defence of a research dissertation.
Admission Requirements
The minimum academic requirement for admission to the PhD program is normally a recognized Master's degree in engineering. Applicants are usually required to have completed a Bachelor’s and a Master’s degree from a recognized post-secondary institution and must have achieved a minimum B average in their Master’s program. Applicants must also have demonstrated strong potential for research. A strong recommendation from the MASc advisor is necessary. Direct admission to the PhD program from a Bachelor's program is rarely granted. Applicants requesting direct admission must hold a bachelor's degree with exceptionally high academic standing and have related research experience. Such applicants should discuss this option with the Associate Director, Graduate Studies at the earliest opportunity.
Program Requirements
The prescribed program of study must consist of no fewer than 2.0 credits in addition to those taken as part of the MASc degree. At least 1.0 of the credits must be engineering graduate courses. Of the remaining 1.0 credits, 0.5 credits must be at the graduate level, and the other 0.5 credits may be graduate credits or senior undergraduate engineering credits. Depending on the student's background, the advisory committee may specify more than 2.0 credits, including undergraduate make-up courses. If make-up courses are deemed necessary, they will be considered additional courses.
The qualifying examination as outlined in the Graduate Calendar is held by the end of the fourth semester but no later than the fifth semester after the student has completed the required courses